Page 1 of 1

Bit Holder

PostPosted: Tue Nov 07, 2017 11:05 pm
by fredfow3
Hey all,

Made a new bit holding tray. Gleened ideas from OpenBuilds and other internet sources.

I thought it came out pretty good...

bit_holder.jpg
Bit Holder


Big_Bit_Tray.crv3d.zip
Bit Holder - Aspire file
(1.19 MiB) Downloaded 63 times

Re: Bit Holder

PostPosted: Tue Nov 07, 2017 11:32 pm
by corlewg
Looks very nice and useful! Thanks for sharing

Re: Bit Holder

PostPosted: Fri Nov 10, 2017 2:28 am
by Oldmanofgf
Thanks for posting and sharing your project
I have been thinking about making some sort of bit storage your idea looks good will have to think where I want to put one as I am running out of room.
Thanks
Glenn

Re: Bit Holder

PostPosted: Fri Nov 10, 2017 4:25 am
by 4DThinker
After a few variations of bit holders (for router tables usually) that eventually filled up with wood bits, I've started making them with a top hole just a little larger than .25, and a through hole 3/16". This lets any debris that drops into empty holes drop out when you pick up the bit holder. Also helps if the bit holder is screwed to the side of a router table cabinet.

4D