by dealguy11 » Sat Sep 30, 2017 3:31 am
The 2-rail sweep is the right tool in v4.5 for this model. Not sure why you would resist it.
I don't normally provide example files any more because I think people learn better when they create the models themselves. However, I did prepare this file, using a 2-rail sweep. Notice that I made the sweep a little wider than the actual part so that the tool will deal with the edges gracefully. I would re-toolpath it if I were you as I didn't make any attempt to put in sensible numbers for the toolpaths.
- Attachments
-
Corbel.crv3d
- (392.5 KiB) Downloaded 44 times
Steve Godding
D&S Artistic Woodworking http://www.dsartisticwood.com