more stair tread work

This is the place to post images of work produced using Aspire

more stair tread work

Postby stankern » Fri Aug 18, 2017 6:53 pm

With aspire 9.010 went at the stair tread trying to cut down the machine time and also adding a reverse type cut or climb vs conventional hoping to clean
up the cut from the V90 bit as different wood grains act differently when machined (shredded looking)
The time has been cut a lot , but I had to do the 2 runs climb and conventional and the wood looks 99% better
looks like these can be done at less than 10 min

https://youtu.be/zG7loPOWpks second run
Attachments
one.jpg
two.jpg
three.jpg
stankern
Vectric Wizard
 
Posts: 416
Joined: Tue Nov 27, 2007 3:21 pm
Location: ontario canada

Return to Aspire - Gallery

Who is online

Users browsing this forum: No registered users and 10 guests