Page 1 of 1

At Disney no one can hear you scream

PostPosted: Wed Aug 02, 2017 6:57 pm
by nicksilva
this was just a quick cut prototype done on the laser of a M.Mouse/Alien hybrid. The laser doesn't give all the same detail on a 3d model as the CNC does, but this gives me a good estimate of what it will look like and whether to proceed with the big one. This is 1.25" tall. Because the (other) evil empire wouldn't want me selling this I'm not going to proceed with the larger one. At least we have something to laugh about. Again, not a lot of sharp detail, but it was just a what if? test.

Model was done in Aspire and exported as a 16 bit greyscale so I can cut it on the laser.