At Disney no one can hear you scream

This is the place to post images of work produced using Aspire
Post Reply
nicksilva
Vectric Craftsman
Posts: 298
Joined: Thu Aug 21, 2014 8:13 pm
Model of CNC Machine: ULS M300, Rockler 60th Ann. Shark
Location: Dallas, TX USA
Contact:

At Disney no one can hear you scream

Post by nicksilva »

this was just a quick cut prototype done on the laser of a M.Mouse/Alien hybrid. The laser doesn't give all the same detail on a 3d model as the CNC does, but this gives me a good estimate of what it will look like and whether to proceed with the big one. This is 1.25" tall. Because the (other) evil empire wouldn't want me selling this I'm not going to proceed with the larger one. At least we have something to laugh about. Again, not a lot of sharp detail, but it was just a what if? test.

Model was done in Aspire and exported as a 16 bit greyscale so I can cut it on the laser.
Attachments
FullSizeRender (2).jpg
"Out of my mind. Back in 5 Minutes."

Post Reply