I made these stands to display my items at shows. The 1/8" ones are laser cut, but could be cut with a mill as well if the spacing is increased and tabs added. The 1/4" ones were also laser cut, but could be milled too. These are nice because they are quick and easy to take apart and set up and they hold most of my pieces in a good angle for viewing. The 1/8" ones are set up for a 12" x 24" piece of 1/8" mdf. The 1/4" ones are set up for a 16" x 8" piece of 1/4" mdf or plywood.
- 1_4 in display racks.crv
- (34 KiB) Downloaded 75 times
- Display racks.crv
- (63 KiB) Downloaded 65 times
Vectric Aspire, Cut3D, VCarve Pro, AutoCAD lite, Draftsight, Corel Draw X6, ViaCAD Pro 9, W 10