Harley Edgelits

[dwilli9013]

Couple of Edgelits completed to be raffled off at a Bikers Against Child Abuse event.
Got the files off another Facebook group for this purpose.
Material=.341 Cast Acrylic
Base Material= Red Oak
Diamond drag bit for engraving.
"0" 1/4 inch bit for profiles. 8000 RPM @ 20 IPM. (best chip load I have seen to date and edges as smooth as glass.)
Finish Pecan Stain, 4 coats shellac, 4 coats johnson paste wax hand buffed.
Bases screwed together with #6 wood screws and hot glued cushions over screw heads.

Fun little project for a good cause. Anxious to see what they raffle off for.

[highpockets]

Dwayne,

I really like the design, not the usual same old same old HD design.

[dwilli9013]

Dwayne,

I really like the design, not the usual same old same old HD design.

I can post the files if you like John.
I like the variation also. Gentle break from the norm.

[COWBOY1296]

I recognize them from facebook.

[CrowsWW]

Dwayne,

WOW those are awesome. you did a great job!
I would like the files if it is possible I know a few Harley owners who would love these.

[dwilli9013]

Here are the files used to create the 2 edgelits. This is not my design I downloaded these from a group on Facebook.
I then manipulated them a bit to suite my needs.

[highpockets]

Thanks for sharing Dwyane!

[CrowsWW]

Thanks for the files Dwayne.

[Beltramidave]

I like them Dwayne!! Can you share your diamond drag settings? I am thinking of trying it on the back of a mirror.

Thanks
Dave

[dwilli9013]

I like them Dwayne!! Can you share your diamond drag settings? I am thinking of trying it on the back of a mirror.

Thanks
Dave

Not a problem. Here you go.

Dwayne

[Hunterland]

Thanks for the files I will put them to good use and post a finished pic. thanks again Don

[tajohns]

Thanks for the files, I appreciate it!

Tom

[Creation in Wood]

Great job, love the design.