Beer Flight Serving Tray

Post by **SteveNelson46** » Wed Aug 24, 2016 7:36 pm

I finally finished the order of 10 of these. They will be used to serve a "flight" of sample craft beers.

Post by **MTSO** » Wed Aug 24, 2016 8:23 pm

Very nice, great pizza theme. What type of wood did you use and how long did it take to cut?.

regards

Brian

Post by **SteveNelson46** » Wed Aug 24, 2016 8:57 pm

MTSO wrote:Very nice, great pizza theme. What type of wood did you use and how long did it take to cut?.

regards

Brian

I only have a Carvewright so everything had to be exported as an .stl, imported and carved as raster. Since the Carvewright software has absolutely no control of the bit (speed, stepover, etc) I was limited to only the selections given. Carved on "optimal", which is the best and slowest it took almost 7 hours to cut each one. Even then the quality wasn't all that great. Especially on the small text. I sure wish there was some options for importing Gcode but it is a highly proprietary machine and they are very adamant about keeping it that way so I don't think that will happen any time soon.

Post by **SteveNelson46** » Thu Aug 25, 2016 12:43 am

I forgot to mention in my previous that the wood is Red Oak.

Post by **ChrisInEstes** » Thu Aug 25, 2016 7:41 pm

Really nice beer flights... the nicest I've seen!

Chris

Post by **cstoutr** » Sat Oct 29, 2016 5:39 am

I did a few myself

Vectric Customer

Beer Flight Serving Tray

Beer Flight Serving Tray

Re: Beer Flight Serving Tray

Re: Beer Flight Serving Tray

Re: Beer Flight Serving Tray

Re: Beer Flight Serving Tray

Re: Beer Flight Serving Tray