Page 1 of 1

photo to engraving

PostPosted: Thu Feb 04, 2016 7:34 pm
by cottagecraftsman
I've been posting these to Facebook, but haven't here yet.
This is an ongoing project to effectively transform a photo to a true 2.5d carving from 3/4" to 1 1/4" in depth.

Re: photo to engraving

PostPosted: Fri Feb 05, 2016 12:45 pm
by davemartin88
Nice, have you carved one yet? How large will the finished project be?

Re: photo to engraving

PostPosted: Fri Feb 05, 2016 7:03 pm
by Creation in Wood
Nice project. I have been trying to figure out how to do a photo carve of my niece.
What process did you use to create the 3d Carved image?

Re: photo to engraving

PostPosted: Fri Feb 05, 2016 7:46 pm
by LittleGreyMan
Hi,

Same question as Doug.

As I understand it, you have a specific process to transform any picture into a 3D bas-relief?

Or did you "simply" use the usual process of bas-relief designing in Aspire?