Beer Flight

This is the place to post images of work produced using Aspire

Beer Flight

Postby Mike-S » Sun Nov 22, 2015 11:09 pm

Beer Flight anyone?

1/2" poplar carved with a 40 deg V-bit.
Red elm gel stain and poly finish.
The brewery is in Ramona, CA.
Attachments
chuckalek.jpg
User avatar
Mike-S
Vectric Wizard
 
Posts: 953
Joined: Mon Jun 13, 2011 6:45 am
Location: Hayesville, NC
Model of CNC Machine: Joe's Hybrid 4x4 (but 3x3)

Re: Beer Flight

Postby mikeacg » Mon Nov 23, 2015 3:03 pm

Very nice Mike! I know what my favorite brewer will be getting for Christmas! Can you share rough dimensions?

Mike
User avatar
mikeacg
Vectric Wizard
 
Posts: 610
Joined: Sun Nov 02, 2008 10:53 pm
Location: Newberry, MI
Model of CNC Machine: Camaster Stinger, Sidewinder, SB 4x4

Re: Beer Flight

Postby Mike-S » Mon Nov 23, 2015 4:26 pm

Sure.
22" x 5.5" material leaves room for hold-downs.
Glass pockets are 0.125" deep cut with a 1" cove bit.
I know the purists don't want to hear this but the edges were done with a roundover bit on a table router after the profile cut released the flight.
Attachments
beerflightvectors.jpg
beer-fltsGlassONEInchDISHcut.dxf
(147.53 KiB) Downloaded 164 times
User avatar
Mike-S
Vectric Wizard
 
Posts: 953
Joined: Mon Jun 13, 2011 6:45 am
Location: Hayesville, NC
Model of CNC Machine: Joe's Hybrid 4x4 (but 3x3)

Re: Beer Flight

Postby mikeacg » Mon Nov 23, 2015 7:31 pm

Thanks for the drawing Mike! I will make good use of it! I promise to share pictures! :)
User avatar
mikeacg
Vectric Wizard
 
Posts: 610
Joined: Sun Nov 02, 2008 10:53 pm
Location: Newberry, MI
Model of CNC Machine: Camaster Stinger, Sidewinder, SB 4x4

Re: Beer Flight

Postby ChrisInEstes » Mon Nov 23, 2015 8:08 pm

I see one HUGE problem with it, Mike...

The glasses aren't full of beer!

Chris
Aspire 8.5 - PhotoVCarve - FlexiEXPERT 11
User avatar
ChrisInEstes
Vectric Wizard
 
Posts: 779
Joined: Fri Jul 17, 2009 8:00 pm
Location: Estes Park, Colorado, USA
Model of CNC Machine: Vytek 4' X 8' - Perske Spindle - Mach3

Re: Beer Flight

Postby Mike-S » Tue Nov 24, 2015 12:25 am

Ah, but they were..... :wink:
User avatar
Mike-S
Vectric Wizard
 
Posts: 953
Joined: Mon Jun 13, 2011 6:45 am
Location: Hayesville, NC
Model of CNC Machine: Joe's Hybrid 4x4 (but 3x3)


Return to Aspire - Gallery

Who is online

Users browsing this forum: No registered users and 15 guests