I rarely use the one I have but find it handy for marking where the double stick tape goes on sheets of styrene, pvc, dibond, etc. when cutting out a number of shapes for certain clients. I always try to avoid the bit cutting thru the adhesive .martin54 wrote:Funny how sometimes an older thread gets a new lease of life because someone comes across it
Don't remember reading this post when it was originally put on the forum, its one thing I have never tried with the cnc & probably never will, being a signmaker & having a vinyl plotter that is actually designed to work with pens as well as blades I don't have the need to use the CNC
1st use of plotter pen
- galerdude
- Vectric Craftsman
- Posts: 180
- Joined: Sun Dec 12, 2010 7:39 am
- Model of CNC Machine: Joe's 4x4 Hybrid R&P Evolution
- Location: Spokane, WA USA
Re: 1st use of plotter pen
Regards,
Gale
Gale
-
- Vectric Wizard
- Posts: 442
- Joined: Fri Jun 06, 2008 4:41 pm
Re: 1st use of plotter pen
I have the widgetworks pen that works great. It uses a sleeve and a weight to let the pen slide up and down so no mashed points.