Two Lithophanes

Post by **Mick Martin** » Sat Nov 10, 2012 3:26 am

Here are two lithopanes made with Aspire. The pictures were taken during my last trip to Honk Kong to visit my brother we had a family reunion .... give it a few seconds to switch

Size 8" x 5 1/2"
Material 1/4" Corian (Glacier White)
1/4" Ball Nose 16,000 rpm - 175 ipm - 15% stepover
1/16" Ball Nose 16,000 rpm - 175 ipm - 8% stepover
Total cutting time 7 Hours

Post by **cabnet636** » Sat Nov 10, 2012 12:40 pm

Nice work !!

Post by **revwarguy** » Sun Nov 11, 2012 6:20 pm

I haven't attempted a lithopane yet, but I must admit I'm always amazed by them. Those are two of the clearest ones I've seen. Very nice job.

Post by **tonydude919** » Sun Nov 11, 2012 7:17 pm

Those are nice lithos. I've done quite a few of them and always gets better with time. Check some of mine out under photo v carve. I would like to see more of your work.

Tony

Post by **mboydraska** » Sun Nov 11, 2012 9:47 pm

Those are amazing, I have tried doing lithos with no luck. But I will keep trying though. Thanks for sharing.

Post by **dhellew2** » Mon Nov 12, 2012 3:58 am

Mike, if you post your litho problems we can help you. Dale

Check out previous posts for lots of tips. Here's a few:

http://www.vectric.com/forum/viewtopic.php?f=29&t=12665
http://www.vectric.com/WebSite/Vectric/ ... family.htm
http://www.vectric.com/forum/viewtopic. ... 14&start=0
http://www.vectric.com/forum/viewtopic.php?f=16&t=13395

Vectric Customer

Two Lithophanes

Two Lithophanes

Re: Two Lithophanes

Re: Two Lithophanes

Re: Two Lithophanes

Re: Two Lithophanes

Re: Two Lithophanes