Large USCG Walnut Designs

Post by **NSchlee** » Wed May 25, 2011 9:34 pm

Here's a 1.5" x 16" x 40" walnut USCG design being carved. And another 1.5" x 15" x 20" USCG Diver Helmut carving sanded and lacquered. I used a .5" bit for the roughing and a .125" ball nose for the finish pass.

Neal

Post by **buck4** » Wed May 25, 2011 10:52 pm

Very-Very Nice!!!!!!!!! The Helmut looks great,

Post by **Mick Martin** » Wed May 25, 2011 11:00 pm

I agree VERY nice work

Post by **zeeway** » Thu May 26, 2011 12:21 am

That helmet has great detail and a very good finish. Good work.

Angie

Post by **Phil** » Thu May 26, 2011 1:29 pm

Excellent work, Neal. Your Helmut shows what Aspire can do in capable hands.

Phil

Post by **esteeme1** » Thu May 26, 2011 2:12 pm

Outstanding work! Thanks for posting.

Post by **NSchlee** » Thu May 26, 2011 4:48 pm

Thanks to All!

Neal

Post by **Boltz** » Thu May 26, 2011 5:55 pm

Nice work! I love carving walnut. That helmet is excellent!

I'm wondering if you've that logo piece vacced down, or simply held from sliding around by the block? If it wasn't for that block I'd think the walnut was glued to the backer board, and the backer board was held by vacuum.

That looks like a Multicam, with the phenolic square grid table, and the primer colored gray paint, with which I'm well familiar. I'm guessing M-series based on the red logo? Mine is an MG and has a blue logo. If it's got an H-board controller we should swap tips and tricks.

-Jim Hart

Vectric Customer

Large USCG Walnut Designs

Large USCG Walnut Designs

Re: Large USCG Walnut Designs

Re: Large USCG Walnut Designs

Re: Large USCG Walnut Designs

Re: Large USCG Walnut Designs

Re: Large USCG Walnut Designs

Re: Large USCG Walnut Designs

Re: Large USCG Walnut Designs