Page 3 of 3

Re: Glazing your 3D Carving - A Step by Step Guide

PostPosted: Mon Dec 21, 2009 4:23 am
by Butch
Well this is probably old news now, but I wanted to show my latest project using the techniques I learned here.
I made this cutting board out of maple with purple heart edges. Then carved the grapes from the Aspire disc.
I then did the cleanup sanding. Applied two coats of sanding sealer. I wanted to leave some 'tooth' to the wood. I then painted with acrylic paint. It took two coats of paint to get the proper shading. I then highlighted the grapes and leaves with a wet towel and 600grit sand paper. I let it dry for 24 hours then finished with two coats of lacquer.
It is 10x17" x 1" thick. The other side was left raw and then I used mineral oil and let it soak in. This goes in a 9' hutch with wine and wine glasses. I hope to finish the hutch up this week, but thought this turned out well enough to show.
Again thanks for the tutorial, I keep coming up with ways to use it. Learning from others is much cheaper than teaching your self.

Re: Glazing your 3D Carving - A Step by Step Guide

PostPosted: Mon Dec 20, 2010 7:01 pm
by mtylerfl
Wow, Butch! That is really nice! Great project!

Re: Glazing your 3D Carving - A Step by Step Guide

PostPosted: Sat Jun 04, 2011 9:19 pm
by mountaincraft
Thank you Tim.. This is very timely for me...

Re: Glazing your 3D Carving - A Step by Step Guide

PostPosted: Sat Oct 15, 2011 5:17 pm
by pannie
very good work Tim
thank you

pannie

Re: Glazing your 3D Carving - A Step by Step Guide

PostPosted: Sun Feb 02, 2014 6:09 pm
by bill_w
Excellent, just what I needed..Thank you.

Re: Glazing your 3D Carving - A Step by Step Guide

PostPosted: Fri Jul 11, 2014 1:53 am
by Brian@Premier
Awesome job Tim! Can't wait to try it out.

-Brian

Re: Glazing your 3D Carving - A Step by Step Guide

PostPosted: Fri Aug 19, 2016 1:10 am
by Deerpark Creations
Very nice work Tim
Thank you
Rick

Re: Glazing your 3D Carving - A Step by Step Guide

PostPosted: Fri Apr 21, 2017 10:08 pm
by frank131313
Thanks i pick-up :D