I was just watching the newly re-released tutorial of the Double Sided Marlin. Good refresher.
I did notice one great tip that I don't remember being mentioned. On a double sided project, if you hold down the Ctrl key, the bottom right status area displays "Thickness: xxx". It calculates the material thickness at the position of the cursor. REALLY useful.
Thickness Display
- mezalick
- Vectric Wizard
- Posts: 2970
- Joined: Mon Nov 03, 2008 9:07 am
- Model of CNC Machine: Camaster Cobra
- Location: Philadelphia, PA USA
- Contact:
Re: Thickness Display
Good tip,
Thanks for pointing that out.
Michael
Thanks for pointing that out.
Michael
Michael Mezalick
https://www.youtube.com/user/mezalick
mm@mezalick.com
https://www.youtube.com/user/mezalick
mm@mezalick.com
- SteveNelson46
- Vectric Wizard
- Posts: 2282
- Joined: Wed Jan 04, 2012 2:43 pm
- Model of CNC Machine: Camaster Stinger 1
- Location: Tucson, Az.