Page 1 of 1

Cutting a sign bigger than my table

Posted: Wed Mar 13, 2019 8:31 pm
by gene8522
My diy has a cutting area of about 50" x 26". I need to make a sign that is 84" x 24".
Is there a way, using Aspire 9.5 to cut the left side of the sign then move the sign over and
cut the right half so the vectors will stay in line?

Re: Cutting a sign bigger than my table

Posted: Wed Mar 13, 2019 8:35 pm
by rig gap
Check out the tiling tutorial...I don't see any reason why you can't do that.

Re: Cutting a sign bigger than my table

Posted: Wed Mar 13, 2019 9:05 pm
by gene8522
rig gap wrote:Check out the tiling tutorial...I don't see any reason why you can't do that.
Thanks, rig gap,
This is just what I was looking for. I never thought of looking in "Toolpath" for the tile toolpath.