Cutting a sign bigger than my table

This section is for useful tips and tricks for Aspire
Post Reply
gene8522
Posts: 34
Joined: Sun Nov 20, 2011 6:13 pm
Model of CNC Machine: EVO Shop built
Contact:

Cutting a sign bigger than my table

Post by gene8522 »

My diy has a cutting area of about 50" x 26". I need to make a sign that is 84" x 24".
Is there a way, using Aspire 9.5 to cut the left side of the sign then move the sign over and
cut the right half so the vectors will stay in line?

rig gap
Vectric Craftsman
Posts: 134
Joined: Fri Jan 03, 2014 1:00 am
Model of CNC Machine: Home built aluminum and steel 3 X 4 CNC
Location: Charlotte, NC

Re: Cutting a sign bigger than my table

Post by rig gap »

Check out the tiling tutorial...I don't see any reason why you can't do that.

gene8522
Posts: 34
Joined: Sun Nov 20, 2011 6:13 pm
Model of CNC Machine: EVO Shop built
Contact:

Re: Cutting a sign bigger than my table

Post by gene8522 »

rig gap wrote:Check out the tiling tutorial...I don't see any reason why you can't do that.
Thanks, rig gap,
This is just what I was looking for. I never thought of looking in "Toolpath" for the tile toolpath.

Post Reply