3d Model Finishing Pass
Posted: Wed Feb 06, 2019 1:43 pm
Hello, I am a newbie at everything CNC, including using this software. I have a 3d model. On top of that model I created a vector shape, and in the modeling tab made that into a 3d model. I then did a circular array of that model. The entire model was finished with a 1/8th Ball Nose. The problem is that I made some small inlays on top of each of those 3d shapes in the array that the 1/8th bit does not capture. Is there a way to grab each of those shapes in the array and run another finishing pass with a 1/16th Ball Nose? I highlighted the vector of the 3d shapes in the array and ran a 3d model finishing pass and that did not work, it ran the entire model.
Thanks
Thanks