Page 1 of 1

Gravograph Compatibility

PostPosted: Tue Jan 01, 2019 3:07 pm
by DougN
I have recently acquired a used Gravograph M40. The software for this is primal at best. After numerous attempts contacting Gravograph and their so-called representative for the last two months I have not received any acknowledgement at all. In all fairness I have found their tech support to be excellent.

Running Aspire, I have noticed drivers for other Gravograph equipment. To use Aspire for the M40 would be great. Any drivers for the M40 machine?

Thanks in advance.

Re: Gravograph Compatibility

PostPosted: Tue Jan 01, 2019 3:50 pm
by Adrian
As long as the control software is the same as the other models the Gravograph drivers should work I would think. It's not the hardware that the output from the Vectric software operates with it's the control software.

Re: Gravograph Compatibility

PostPosted: Tue Jan 01, 2019 9:03 pm
by DougN
I'll have to play with it for a bit. Thanks for the reply.