Vectric Customer

I have recently acquired a used Gravograph M40. The software for this is primal at best. After numerous attempts contacting Gravograph and their so-called representative for the last two months I have not received any acknowledgement at all. In all fairness I have found their tech support to be excellent.

Running Aspire, I have noticed drivers for other Gravograph equipment. To use Aspire for the M40 would be great. Any drivers for the M40 machine?

Thanks in advance.

As long as the control software is the same as the other models the Gravograph drivers should work I would think. It's not the hardware that the output from the Vectric software operates with it's the control software.

I'll have to play with it for a bit. Thanks for the reply.