kaetamer wrote:What I'm asking is can you use the tool path generated by a SBN tool with a TBN loaded into the spindle?
kaetamer wrote:What I was (clumsily) trying to convey by the terms "TBN tool path" and SBN tool path" are the tool paths generated by either using a TBN or SBN as the tool used to generate the machining tool path.
What I'm asking is can you use the tool path generated by a SBN tool with a TBN loaded into the spindle? Some of the earlier comments suggested the taper rarely interferes with the carving (except on true vertical walls); I'm wondering if anyone does this to benefit from the added strength of the TBN and by extension, shorter carving times.
Users browsing this forum: No registered users and 3 guests