Winterdragon wrote:Yes this is basically what I was looking for. Thank you so much,
I was looking in the toollbars. Im assuming that since the Derby cover is already "machined", I would just leave out the 3d paths for the shape and focus on just the engraving part. Does this sound about right or is there something else I need to do before?
I did the 3D finish on the dome, then the Pocket engrave and projected to 3d model.. Heres what I got so far. It appears that the design does conform to the curvature of the done.. Fingers Crossed.
Users browsing this forum: Google [Bot] and 3 guests