Rest finish type machining on a sign.

This section is for useful tips and tricks for Aspire

Rest finish type machining on a sign.

Postby rsetina » Tue Jul 11, 2017 6:05 am

I'm making some signs for a friend of mine and with the font I'm using, the .5 inch end mill won't completely remove all the material from the number four inside the triagular area at the top of the number. The corners aren't clean either where the leg and cross bar meet. My question is, is there a way to matching the sign with the .5 inch end mill and just clean the rest of the number four with a .25 inch end mill?

I uploaded an image and I hope it upload to the post so you can see to what I'm referring
Address Signs.jpg
Rick

Shark HD 2.0
rsetina
Vectric Craftsman
 
Posts: 188
Joined: Sun May 05, 2013 6:37 pm
Model of CNC Machine: Shark HD 2.0

Re: Rest finish type machining on a sign.

Postby FixitMike » Tue Jul 11, 2017 7:29 am

Yes. You use the Pocket toolpath and check the Use Larger Area Clearance Tool box. The smaller bit will make all of the inside corners sharper.

I would suggest using 3/16" and 1/2" diameter cutters for this to get even sharper inside corners.
Good judgement comes from experience.
Experience comes from bad judgement.
User avatar
FixitMike
Vectric Wizard
 
Posts: 1202
Joined: Sun Apr 17, 2011 5:21 am
Location: Renton, WA USA
Model of CNC Machine: Shark Pro Plus (modified)

Re: Rest finish type machining on a sign.

Postby Adrian » Tue Jul 11, 2017 8:37 am

If you don't see the Larger Area Clearance Tool section be sure to check the Show advanced tool options box at the top of the form. By default it's off so you won't see the other options.
User avatar
Adrian
Vectric Archimage
 
Posts: 7411
Joined: Thu Nov 23, 2006 2:19 pm
Location: Surrey, UK
Model of CNC Machine: ShopBot PRS Alpha 96x48

Re: Rest finish type machining on a sign.

Postby rsetina » Tue Jul 11, 2017 2:43 pm

Thanks for the info guys. I'll look for it. I knew I'd get an answer to my question here.
Rick

Shark HD 2.0
rsetina
Vectric Craftsman
 
Posts: 188
Joined: Sun May 05, 2013 6:37 pm
Model of CNC Machine: Shark HD 2.0


Return to Aspire - Tips and Tricks

Who is online

Users browsing this forum: No registered users and 6 guests