mill a block
-
- Posts: 8
- Joined: Tue May 24, 2016 10:28 am
- Model of CNC Machine: chinese 3060
mill a block
Is there a way to mill a block zeoing the base to leave x amount on say 10mm thick? Please
- Mike-S
- Vectric Wizard
- Posts: 1123
- Joined: Mon Jun 13, 2011 6:45 am
- Model of CNC Machine: Joe's Hybrid 4x4 (but 3x3)
- Location: Hayesville, NC
Re: mill a block
Is this what you're looking for?
Then just tell it to pocket off the top of the material (here 1mm) to get a 10mm thick finished piece.
Then just tell it to pocket off the top of the material (here 1mm) to get a 10mm thick finished piece.