Page 2 of 2

Re: Problems with final product

PostPosted: Fri May 20, 2016 3:42 am
by tonybell96
Thanks, set the machine strategy to Raster and no line.... very strange indeed....'

Re: Problems with final product

PostPosted: Fri May 20, 2016 4:28 pm
by Pete Cyr
Perhaps not, but it appears he is cutting a negative of the model - either there is an incorrect measurement of the material being cut or the setup is fouled somehow.

Re: Problems with final product

PostPosted: Fri May 20, 2016 7:48 pm
by Mike-S
it appears he is cutting a negative of the model

Optical illusion because of lower left lighting and rotated picture, it's a normal carve.
I tried to duplicate and I believe you lost some Z steps during the carve. Since the middle zone is cut last, the change in Z showed up in that area.