Problems with final product

This section is for useful tips and tricks for Aspire

Re: Problems with final product

Postby tonybell96 » Fri May 20, 2016 3:42 am

Thanks, set the machine strategy to Raster and no line.... very strange indeed....'
tonybell96
 
Posts: 13
Joined: Sun Nov 02, 2014 5:41 am
Model of CNC Machine: Shark HD

Re: Problems with final product

Postby Pete Cyr » Fri May 20, 2016 4:28 pm

Perhaps not, but it appears he is cutting a negative of the model - either there is an incorrect measurement of the material being cut or the setup is fouled somehow.
Pete Cyr
Vectric Craftsman
 
Posts: 182
Joined: Sun May 15, 2011 4:19 pm
Model of CNC Machine: Camaster Stinger II

Re: Problems with final product

Postby Mike-S » Fri May 20, 2016 7:48 pm

it appears he is cutting a negative of the model

Optical illusion because of lower left lighting and rotated picture, it's a normal carve.
I tried to duplicate and I believe you lost some Z steps during the carve. Since the middle zone is cut last, the change in Z showed up in that area.
Attachments
SWOcarve2.jpg
offsetmidmissing.jpg
User avatar
Mike-S
Vectric Wizard
 
Posts: 1093
Joined: Mon Jun 13, 2011 6:45 am
Location: Hayesville, NC
Model of CNC Machine: Joe's Hybrid 4x4 (but 3x3)

Previous

Return to Aspire - Tips and Tricks

Who is online

Users browsing this forum: No registered users and 4 guests