I am looking to make 4" or 5" square bed posts that are 48" and 36" long. I would like to make them 4" or 5" spiral square with and arc from top to bottom. Is this even possible? If so what is the best way to proceed?
Well, I'm back to report... It's " possible" ( and I use the term loosely ) to create it in Aspire. There's a lot of distortion with this type of shape. I would mostly likely use a different program to create the shape and then bring it into Aspire for cutting.. The straight twist is much easier to make.
But as I said, it's " Possible "
Michael 'All the news that fit to print "
Michael Mezalick https://carveddetails.com email@example.com