I have Aspire since beginning of this year and I start to love it.
I created toolpaths this way:
1. autocad light file
2. dxf out
3. Filou to create toolpath
4. run it on our machine with CNCGraf
This is a long way and I want to save time using now Aspire.
Till now I just found out that I can load and place a dxf. But I want to draw all parts in one file and then create all toolpaths when setting different zeropoints on the parts inside the dxf.
I attached a dxf to show better what I mean.
I hope it is easy to set different zero points like "end of a line" or "crossing of 2 lines".
Hope for help! All the best
Ralph
