Updating all tools at once?

This forum is for general discussion about Aspire

Updating all tools at once?

Postby zaaephod » Tue Feb 10, 2009 8:17 pm

Good morning :)

I did some upgrading on my machine, some reinforcement, and new gecko drives, which now allows me to run faster on many cuts. I went through and increased the speeds on several tools.

My question is, I have lots of old designs, and if I load up one of the old ones, and re-export the toolpaths, it will use the old settings from the tools, instead of the new updated ones. I tried using 'recalculate all toolpaths' thinking it would use the new tool information, but it doesn't.

Is the only way to update these is to open each toolpath, and re-select the tool?

Vectric Craftsman
Posts: 140
Joined: Fri Apr 11, 2008 1:05 am
Location: Earth, Milky Way

Return to Aspire - General

Who is online

Users browsing this forum: No registered users and 31 guests