It would make my life a lot easier if, in the "Preview Toolpath" section, I could reset each toolpath separately. For example, I run the first five toolpaths only to discover toolpath five needs work. Now, I have to do a "Reset Toolpaths", fix my problem, then sit through four toolpath simulations that I already know work.
I know this might be a small thing, but when you have to redo as much as I do, I spend an awful lot of time watching things that I know work.
Regards,
Joe
Feature Request...
- GripUs
- Vectric Wizard
- Posts: 806
- Joined: Thu Jan 18, 2007 2:07 pm
- Location: San Angelo, Texas
- Contact:
Feature Request...
Ham and eggs - Inconvenient for the chicken. A total commitment for the pig.
http://www.gripus.com/
http://www.gripus.com/