Feature Request...

This forum is for general discussion about Aspire

Feature Request...

Postby GripUs » Mon Dec 08, 2008 12:07 am

It would make my life a lot easier if, in the "Preview Toolpath" section, I could reset each toolpath separately. For example, I run the first five toolpaths only to discover toolpath five needs work. Now, I have to do a "Reset Toolpaths", fix my problem, then sit through four toolpath simulations that I already know work.

I know this might be a small thing, but when you have to redo as much as I do, I spend an awful lot of time watching things that I know work.


Ham and eggs - Inconvenient for the chicken. A total commitment for the pig.
User avatar
Vectric Wizard
Posts: 794
Joined: Thu Jan 18, 2007 2:07 pm
Location: San Angelo, Texas

Return to Aspire - General

Who is online

Users browsing this forum: No registered users and 35 guests