Post Processor: Shopbot (arc)(inch)(alpha_control)

This forum is for general discussion about Aspire

Post Processor: Shopbot (arc)(inch)(alpha_control)

Postby Rcnewcomb » Sun Nov 09, 2008 4:18 pm

Obviously I have too much time on my hands to notice things like this....

The first line of output from the Shopbot (arc)(inch)(alpha_control) post processor reads:
'File created in VCarve Wizard
But I had generated the file in Aspire. Maybe a more generic: "File created by Vectric" would be a better solution in the next release.

FYI, I worked on a large plaque yesterday that I had designed in Aspire and it cut beautifully.

The Vectric team is the best!
- Randall Newcomb
10 fingers in, 10 fingers out - another good day in the shop
User avatar
Vectric Wizard
Posts: 3143
Joined: Fri Nov 04, 2005 5:54 am
Location: San Jose, California, USA
Model of CNC Machine: GCnC/WinCNC

Return to Aspire - General

Who is online

Users browsing this forum: No registered users and 32 guests