Font Issue

This forum is for general discussion about Aspire
Post Reply
Tscholl
Posts: 28
Joined: Fri Mar 01, 2013 4:55 pm
Model of CNC Machine: Biesse Skill

Font Issue

Post by Tscholl »

I am trying to cut a small sign with Alcubierre font. It an open font. When I cut the sign I get ‘bumps’ or overlaps. Notice on the letters g, u and r. The bumps don’t show when I run the preview. I am running this on a Biesse Skill. The VPOINT bit is a 60 degree cutter. Aspire version 9.517. I've attached the crv3d and a pdf of the actual cutout.
Is there a way I can run this file without the bumps?
Thanks
Attachments
font issue.pdf
(1.11 MiB) Downloaded 103 times
MID OFFICE.crv3d
(710 KiB) Downloaded 95 times

User avatar
highpockets
Vectric Wizard
Posts: 3667
Joined: Tue Jan 06, 2015 4:04 pm
Model of CNC Machine: PDJ Pilot Pro

Re: Font Issue

Post by highpockets »

Might want to check that the 60° bit is actually 60°
http://forum.vectric.com/viewtopic.php?t=2164
John
Maker of Chips

User avatar
Rcnewcomb
Vectric Archimage
Posts: 5887
Joined: Fri Nov 04, 2005 5:54 am
Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
Location: San Jose, California, USA
Contact:

Re: Font Issue

Post by Rcnewcomb »

In the file you attached you specified a 90 degree V bit.
Attachments
Bit90.PNG
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop

Tscholl
Posts: 28
Joined: Fri Mar 01, 2013 4:55 pm
Model of CNC Machine: Biesse Skill

Re: Font Issue

Post by Tscholl »

That was it - I had the wrong information in the tool data - thanks

Post Reply