Inlay Pocket in Texture Area Tile

This forum is for general discussion about Aspire

Inlay Pocket in Texture Area Tile

Postby chris77 » Fri Jun 21, 2019 2:09 pm

Hello,

I have cut a texture area tile into a piece of wood that is .774” thick. The thickness of the texture area tile (model thickness) is .375” with a gap above of 0 and a gap below of.399”. After cutting the texture area tile I wanted to do an inlay pocket in this area. I tried doing a cutting depth of .125” and it did not cut deep enough. I tried a different depth and it went too deep. I am wanting it to cut .125” deep into the texture area tile.

Thanks for your help!
chris77
 
Posts: 23
Joined: Sun Mar 31, 2019 12:29 pm
Model of CNC Machine: Laguna

Re: Inlay Pocket in Texture Area Tile

Postby TReischl » Fri Jun 21, 2019 9:19 pm

If you are saying the texture is .375 deep and you want to remove all of it where the inlay pocket goes then you need to set your start depth to .375 and cut depth to .125.

Otherwise you could start at 0 and tell it to cut .5 deep and watch it cut air for a while.
http://www.tedreischl.com

Low Profile CNC Router Vise
User avatar
TReischl
Vectric Wizard
 
Posts: 2713
Joined: Thu Jan 18, 2007 6:04 pm
Location: Leland NC
Model of CNC Machine: 8020 Build 48X36X10 RP 2010 Screenset

Re: Inlay Pocket in Texture Area Tile

Postby chris77 » Fri Jun 21, 2019 9:27 pm

Thanks for your help!
chris77
 
Posts: 23
Joined: Sun Mar 31, 2019 12:29 pm
Model of CNC Machine: Laguna


Return to Aspire - General

Who is online

Users browsing this forum: No registered users and 18 guests