License migration to new computer

This forum is for general discussion about Aspire
Post Reply
hockeyhead
Posts: 4
Joined: Sat Nov 03, 2018 10:49 pm
Model of CNC Machine: Probotix Asteroid

License migration to new computer

Post by hockeyhead »

Hi. I know Vectric allows Aspire to be installed on three PCs at a time; however I am wondering if you throw out a computer can you recover that license? And how would you go about doing that? Thanks.

Bob Reda
Vectric Wizard
Posts: 858
Joined: Wed Aug 16, 2006 7:34 pm
Model of CNC Machine: shopbot 48x48 upgraded prt
Location: Monessen, Pa
Contact:

Re: License migration to new computer

Post by Bob Reda »

all your license details are available at the vectric portal. If you are the original licensee or had a license transferred your info should be there. If it went through shopbot or another agency you will probably have to contact them. If you had it on a computer and are just changing computers that shouldn't be an issue, I have done that many times myself.

Bob

Post Reply