Horrible did I say HORRIBLE
case of operator error!!!!!!!!!
As I said, side 1 went as expected.
After a good nights rest the answer pops into my head.
I should always wait for a good night's sleep before asking questions on the forum. NOTE to self!!!!!!
As I said I flipped the work piece over, zeroed on off the spoil board and total fail.
It is important to note
that you run the roughing toolpath for side 2 NOT
I went out to my CNC and checked the recently run menu and low and behold the roughing toolpath for side 2 was not run!!!!!!!!!!
Sorry for the false alarm, but I'm sure I was not the first nor the last to do this.
The sad part is I name my toolpaths with F1xxx for the first toolpath on the front, F2xxx for the second, etc.
The xxx part is the bit number.
B1xxx for the first toolpath on the back, just so things like this don't occur!!!
Again thanks to all hope this prevents someone else's operator error.
It will bring a chuckle to the CNC user groups I belong to.