I'm having a senior moment here.... Using the Profile Toolpath I can't seem to get the Allowance Offset to work. No matter what I try it's grayed out. What am I missing?
Allowance Offset
- highpockets
- Vectric Wizard
- Posts: 3667
- Joined: Tue Jan 06, 2015 4:04 pm
- Model of CNC Machine: PDJ Pilot Pro
Allowance Offset
John
Maker of Chips
Maker of Chips
- Rcnewcomb
- Vectric Archimage
- Posts: 5918
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: Allowance Offset
You cannot do an offset when profiling ON the vector.
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop
- highpockets
- Vectric Wizard
- Posts: 3667
- Joined: Tue Jan 06, 2015 4:04 pm
- Model of CNC Machine: PDJ Pilot Pro
Re: Allowance Offset
Yea, I know that, sorry about the pic was just on the ON vector option when I took the screenshot. I've tried Outside, Inside, Climb and Conventional cuts. Nothing seems to work.Rcnewcomb wrote:You cannot do an offset when profiling ON the vector.
John
Maker of Chips
Maker of Chips
Re: Allowance Offset
Do you happen to have 'Sharp internal corners' set as an option? If so this will prevent the allowance being used and might be why you are unable to use this option.
- highpockets
- Vectric Wizard
- Posts: 3667
- Joined: Tue Jan 06, 2015 4:04 pm
- Model of CNC Machine: PDJ Pilot Pro
Re: Allowance Offset
Thanks!!! That did the trick...StuC wrote:Do you happen to have 'Sharp internal corners' set as an option? If so this will prevent the allowance being used and might be why you are unable to use this option.
John
Maker of Chips
Maker of Chips