Rotary job issue. Need help.

[jaru-eri]

I refer to my topic in V-carve forum and need help in order to find out why my generated g-codes gives a different machining toolpath than it was shown in the v-carve softvare.

http://forum.vectric.com/viewtopic.php? ... 98#p228998

Are there anybody here who can help me with this issue?

[garylmast]

It's hard to tell by the picture...at first it looked like it might of been rotated 90° in your preview picture, but then again the picture is hard to see. If the rotary rotates once before it starts, I would think you would need to calibrate the A-Axis. Remember it is in degrees rather than inches or millimeters.

Gary

[jaru-eri]

I found a solution for this problem. It was something with the config. setting in Mach3. I got some advice about that setting from a member in cnc-zone that was wrong.

[Rcnewcomb]

I found a solution for this problem.

We look forward to seeing some of your new projects on the rotary.