martin54 wrote:Stone was not one of them, these will be for brass rubbing, do you think the Portland stone will stand up to that? Do you take any special precausions when machining it?
Customer who is actually the Landlord for my Industrial unit asked if I would be able to do them in wood to keep the cost down but she wants them to last for a lot of years
martin54 wrote:I believe you are correct Leo, funny thing is if I contact a supplier for prices they quote imperial sizes lol
Phoned a few places that stock brass & no one could fully answer my questions, some of these were big companies so I would expect them to have a degree of expertise about the products they were selling or is that just me??
Users browsing this forum: No registered users and 20 guests