Touch plate
Touch plate
Hi, I want to make an xyz touch plate but nowhere can I find any instruction how to program it into Universal Gcode. Can anyone help with this please. I am using Vectric Desktop
- Adrian
- Vectric Archimage
- Posts: 14650
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: Touch plate
Depends on the control software you're using. That's where the programming is done.
- martin54
- Vectric Archimage
- Posts: 7349
- Joined: Fri Nov 09, 2012 2:12 pm
- Model of CNC Machine: Gerber 48, Triac PC, Isel fixed gantry
- Location: Kirkcaldy, Scotland
Re: Touch plate
It has nothing to do with vectric software as Adrian has said, if your CNC or the control software you are using has a dedicated forum then you would be better off asking this question there, you may get an answer here if someone has the same set up as you & has a touch plate but people on the forum are using lots of different machines & a range of different control software
Re: Touch plate
Thanks guys, at least you’ve pointed me in the right direction. By the way I’m using the Expro V3 controller from Ooznest so I’ll maybe contact them.