I changed the size of my project but when previewing visible and or all toolpaths, the old size shows up also. And will probably cut it also.
How do I get rid of the old size of the project.
toolpaths
-
- Vectric Apprentice
- Posts: 66
- Joined: Mon Sep 10, 2018 3:21 pm
- Model of CNC Machine: cncrouterparts
Re: toolpaths
I changed the size of my project but when previewing visible and or all toolpaths, the old size shows up also. And will probably cut it also.
How do I get rid of the old size of the project. the new size IS THE SMALLER
How do I get rid of the old size of the project. the new size IS THE SMALLER
-
- Vectric Craftsman
- Posts: 216
- Joined: Sat Feb 03, 2018 2:03 am
- Model of CNC Machine: diy 4 X 4 CNC Router
- Location: So. Cal.
Re: toolpaths
In the preview mode try : reset preview.
mark-s
mark-s
-
- Vectric Apprentice
- Posts: 66
- Joined: Mon Sep 10, 2018 3:21 pm
- Model of CNC Machine: cncrouterparts
Re: toolpaths
mark-s
thanks but did not work
thanks but did not work
-
- Vectric Apprentice
- Posts: 66
- Joined: Mon Sep 10, 2018 3:21 pm
- Model of CNC Machine: cncrouterparts
Re: toolpaths
tried reset preview and recalculate all toolpaths, thanks
but get attached error
but get attached error
- highpockets
- Vectric Wizard
- Posts: 3667
- Joined: Tue Jan 06, 2015 4:04 pm
- Model of CNC Machine: PDJ Pilot Pro
-
- Vectric Apprentice
- Posts: 66
- Joined: Mon Sep 10, 2018 3:21 pm
- Model of CNC Machine: cncrouterparts
Re: toolpaths
high pockets:
"And did you?"
YES
tried reset preview and recalculate all tool-paths
"And did you?"
YES
tried reset preview and recalculate all tool-paths
- highpockets
- Vectric Wizard
- Posts: 3667
- Joined: Tue Jan 06, 2015 4:04 pm
- Model of CNC Machine: PDJ Pilot Pro
Re: toolpaths
But you didn't do what the error message said. Look very closely at the roughing and finishing toolpaths. There's a configuration problem caused by the modifications you made. From the looks of things I'd suspect the Machine Limit Boundary - Selected Vector(s) isn't selected.
John
Maker of Chips
Maker of Chips