I'm getting and update error when going from 9.511 to 9.512 was hoping
so one had already resolved this issue
Update error
-
- Vectric Apprentice
- Posts: 68
- Joined: Tue Mar 02, 2010 10:46 pm
- Model of CNC Machine: Camaster Stinger Epilog Aspire
- Location: Austin TX
- Adrian
- Vectric Archimage
- Posts: 14690
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: Update error
Most likely the program is being held open by an antivirus or backup program. If you reboot the PC and try to run the update file again it should be ok. The update worked fine for me on my three computers.
-
- Vectric Staff
- Posts: 541
- Joined: Wed Jul 19, 2017 11:59 am
- Model of CNC Machine: Craft CNC DS1
Re: Update error
Make sure you closed Aspire. I had a failure like this once that I couldn't reproduce (perhaps a development thing) where Aspire was running in the background. Look for Aspire in the Windows Task Manager. Adrian's suggestion is much more likely though, but just in case.
--------------
Mohamed
++++++++
Mohamed
++++++++
-
- Vectric Apprentice
- Posts: 68
- Joined: Tue Mar 02, 2010 10:46 pm
- Model of CNC Machine: Camaster Stinger Epilog Aspire
- Location: Austin TX
Re: Update error
Adrain's,
Answer worked, when I tried the next day everything worked ok
Thanks
Answer worked, when I tried the next day everything worked ok
Thanks