Positioning Components

This forum is for general discussion about Aspire
Post Reply
User avatar
scovell
Posts: 44
Joined: Sat Jul 16, 2016 4:57 pm
Model of CNC Machine: Shark CNC
Location: O Fallon, MO USA

Positioning Components

Post by scovell »

I am new to aspire, but have been using Vcarve in the past. I am going through the tutorial on how to make leaves and acorns. I am swapping the acorns out with berries in an attempt to model a Christmas wreath. I cannot get the berries to be positioned on top of the leaves. Any suggestions will be helpful. Thank you.
Attachments
leafandberry.crv3d
(1.41 MiB) Downloaded 104 times

User avatar
SteveNelson46
Vectric Wizard
Posts: 2282
Joined: Wed Jan 04, 2012 2:43 pm
Model of CNC Machine: Camaster Stinger 1
Location: Tucson, Az.

Re: Positioning Components

Post by SteveNelson46 »

Set the berry to "Merged". Raise the base height.
Attachments
Holly Leaves.png
Steve

User avatar
scovell
Posts: 44
Joined: Sat Jul 16, 2016 4:57 pm
Model of CNC Machine: Shark CNC
Location: O Fallon, MO USA

Re: Positioning Components

Post by scovell »

Thank you Steve!

Post Reply