Almost OOPS!

This forum is for general discussion about Aspire

Almost OOPS!

Postby spinningwood » Mon Sep 17, 2018 2:18 am

I have a couple different machines I work on. Aspire remembers the post processor I'm using between sessions. When I change projects I make sure I confirm the post processor when saving toolpaths. When I'm working with the same project I have gotten out of the habit of confirming the post processor when I save the toolpaths. Ooops!

When I upgraded to 9.5 everything transferred over. Posts, tool database, etc. What didn't transfer was Aspire's memory of the last post processor I was using. I continued working on my current project after the upgrade. I even converted it to the new rotary job type. What I didn't check was that the post processor was correct when I started saving toolpaths. The new version of Aspire just used the first post it found in my post directory. Sadly, this was not the post I needed.

Fortunately I noticed something was amiss when my spindle didn't turn on when I started my job. Less fortunately, I assumed it was something wrong with the machine since I had just completed a rebuild on it. After a lot of head scratching and hardware troubleshooting it finally dawned on me that the gcode didn't look right. That's because it was for a different machine.

Lesson learned. Always confirm the post processor when saving toolpahts.

Ed
spinningwood
Vectric Wizard
 
Posts: 329
Joined: Wed Aug 12, 2009 2:09 am
Location: Space Coast, Florida
Model of CNC Machine: Taig Mill and Self Built Routers

Return to Aspire - General

Who is online

Users browsing this forum: mark-s, SteveNelson46, Wayne Locke and 31 guests