Aspire simple shape issue V9.508
-
- Vectric Craftsman
- Posts: 186
- Joined: Sun May 06, 2012 2:02 am
- Model of CNC Machine: Two machines, CRP 48x96 and a xylotex
Aspire simple shape issue V9.508
Trying to create a simple shape froom clean closed vectors and the shape is way outside of the lines on both sides. Not even symmetrical even though the vectors are. There are no nodes either in the area it goes off. Ill try to restart the software but...
-
- Vectric Craftsman
- Posts: 186
- Joined: Sun May 06, 2012 2:02 am
- Model of CNC Machine: Two machines, CRP 48x96 and a xylotex
Re: Aspire simple shape issue V9.508
converted to bezier arcs and it worked fine...
Re: Aspire simple shape issue V9.508
Cut the ends off, do not have a closed vector. One of the ends that is not connected used as the cross rail.
-
- Vectric Craftsman
- Posts: 186
- Joined: Sun May 06, 2012 2:02 am
- Model of CNC Machine: Two machines, CRP 48x96 and a xylotex
Re: Aspire simple shape issue V9.508
You need closed vectors to use the create shape tool. I was not attempting a sweep. I created the part already but vectric may want to take a look at this and fix something. The part made had a domed shape, limited to height to produce nice rounded edges. Thanks though...
Re: Aspire simple shape issue V9.508
Sorry, misunderstood what you were doing.
Re: Aspire simple shape issue V9.508
Please do send in the file to support if you can and we will take a look. I tried to recreate the problem from your screenshots but didn't get the same results. Thanks.graffix11 wrote:I created the part already but vectric may want to take a look at this and fix something.
-
- Vectric Craftsman
- Posts: 186
- Joined: Sun May 06, 2012 2:02 am
- Model of CNC Machine: Two machines, CRP 48x96 and a xylotex
Re: Aspire simple shape issue V9.508
Ok I managed to get it to do it again by switching it back to arcs.
Re: Aspire simple shape issue V9.508
A belated thank you for sending in the file. This issue should be fixed in 9.510.
Regards,
Mark.
Regards,
Mark.