Aspire simple shape issue V9.508

This forum is for general discussion about Aspire
Post Reply
graffix11
Vectric Craftsman
Posts: 186
Joined: Sun May 06, 2012 2:02 am
Model of CNC Machine: Two machines, CRP 48x96 and a xylotex

Aspire simple shape issue V9.508

Post by graffix11 »

Trying to create a simple shape froom clean closed vectors and the shape is way outside of the lines on both sides. Not even symmetrical even though the vectors are. There are no nodes either in the area it goes off. Ill try to restart the software but...
Attachments
aspire issue.JPG
aspire issue2.JPG

graffix11
Vectric Craftsman
Posts: 186
Joined: Sun May 06, 2012 2:02 am
Model of CNC Machine: Two machines, CRP 48x96 and a xylotex

Re: Aspire simple shape issue V9.508

Post by graffix11 »

converted to bezier arcs and it worked fine...

garylmast
Vectric Wizard
Posts: 1580
Joined: Fri Oct 23, 2009 4:03 pm
Location: Sandy, Utah

Re: Aspire simple shape issue V9.508

Post by garylmast »

Cut the ends off, do not have a closed vector. One of the ends that is not connected used as the cross rail.
Attachments
Capture.JPG

graffix11
Vectric Craftsman
Posts: 186
Joined: Sun May 06, 2012 2:02 am
Model of CNC Machine: Two machines, CRP 48x96 and a xylotex

Re: Aspire simple shape issue V9.508

Post by graffix11 »

You need closed vectors to use the create shape tool. I was not attempting a sweep. I created the part already but vectric may want to take a look at this and fix something. The part made had a domed shape, limited to height to produce nice rounded edges. Thanks though...

garylmast
Vectric Wizard
Posts: 1580
Joined: Fri Oct 23, 2009 4:03 pm
Location: Sandy, Utah

Re: Aspire simple shape issue V9.508

Post by garylmast »

Sorry, misunderstood what you were doing.

Mark_R
Vectric Staff
Posts: 25
Joined: Wed Mar 07, 2018 11:03 am
Model of CNC Machine: Shopbot

Re: Aspire simple shape issue V9.508

Post by Mark_R »

graffix11 wrote:I created the part already but vectric may want to take a look at this and fix something.
Please do send in the file to support if you can and we will take a look. I tried to recreate the problem from your screenshots but didn't get the same results. Thanks.

graffix11
Vectric Craftsman
Posts: 186
Joined: Sun May 06, 2012 2:02 am
Model of CNC Machine: Two machines, CRP 48x96 and a xylotex

Re: Aspire simple shape issue V9.508

Post by graffix11 »

Ok I managed to get it to do it again by switching it back to arcs.

graffix11
Vectric Craftsman
Posts: 186
Joined: Sun May 06, 2012 2:02 am
Model of CNC Machine: Two machines, CRP 48x96 and a xylotex

Re: Aspire simple shape issue V9.508

Post by graffix11 »

sent

Mark_R
Vectric Staff
Posts: 25
Joined: Wed Mar 07, 2018 11:03 am
Model of CNC Machine: Shopbot

Re: Aspire simple shape issue V9.508

Post by Mark_R »

A belated thank you for sending in the file. This issue should be fixed in 9.510.
Regards,
Mark.

Post Reply