This forum is for general discussion about Aspire
Soapyjoe
Vectric Wizard
Posts: 376 Joined: Mon Aug 10, 2015 8:57 am
Model of CNC Machine: Heiz High Z Machine German manufacture
Location: Derbyshire, England
Post
by Soapyjoe » Wed Jul 18, 2018 10:24 am
I wish to discover the best way of accurately placing a radius on an internal corner... I know it is easy on a square or oblong ... but on a piece shaped like a fat letter T I am struggling a little...
Soapy
Adrian
Vectric Archimage
Posts: 14684 Joined: Thu Nov 23, 2006 2:19 pm
Model of CNC Machine: ShopBot PRS Alpha 96x48
Location: Surrey, UK
Post
by Adrian » Wed Jul 18, 2018 11:05 am
The fillet tool is the easiest way of doing it. Just click on the angle and it replaces it with the radius.
You can also use the offset set tool by offsetting in and out or use the radius gadget.
Soapyjoe
Vectric Wizard
Posts: 376 Joined: Mon Aug 10, 2015 8:57 am
Model of CNC Machine: Heiz High Z Machine German manufacture
Location: Derbyshire, England
Post
by Soapyjoe » Wed Jul 18, 2018 11:54 am
Thanks once again Adrian
Invaluable help