Texture Toolbox problem

This forum is for general discussion about Aspire
Post Reply
pknvectric
Vectric Apprentice
Posts: 61
Joined: Tue May 31, 2016 3:25 pm
Model of CNC Machine: Camaster Cobra & StingerI

Texture Toolbox problem

Post by pknvectric »

Can anyone share with me why I sometimes (but not always) run into this problem while using the Texture Toolbox Gadget? (The "Create Vector Texture works fine - it stays within the boundaries of the grouped vectors I use to create the texture.) But then the TTG overruns the (huge) boundaries of the offset. It seems it does not matter how massive I make the boundaries it largely ignores them...

Update: Strangely... When I rotate the image 90 degrees and run the TTG again the problem goes away...
Attachments
Screen Shot 2018-06-16 at 3.51.25 PM.png
Screen Shot 2018-06-17 at 12.00.49 AM.png
Screen Shot 2018-06-17 at 12.01.08 AM.png
Screen Shot 2018-06-17 at 12.16.56 AM.png

GaryR6
Vectric Wizard
Posts: 401
Joined: Sat May 23, 2009 6:28 pm
Location: AZ

Re: Texture Toolbox problem

Post by GaryR6 »

GO COWBOYS

seanm
Vectric Staff
Posts: 88
Joined: Mon Jul 28, 2014 9:12 am
Model of CNC Machine: 6040 Desktop CNC

Re: Texture Toolbox problem

Post by seanm »

Hi there,

Could you possibly either upload the file for me here or send it me directly to seanm@vectric.com so i cant take a look at why it is not behaving correctly.
There is a new version with some improvement fixes awaiting to be released, so it would be good to ensure this is also fixed before releasing.

Thank you

Sean

Post Reply