I have a 3d carving that has a tree that is cut to a depth of over 1/2". Rather than having straight cut on the sides it would be great is I could give it a more rounded profile using the two rail sweep. Unfortunately, I'm not even sure where to start with such an irregularly shaped item. Any ideas, attached is a file that will show you what it looks like. The tree in question is to the left, the bottom is beach and can be ignored.
Gary
Two Rail Sweep a tree
-
- Vectric Apprentice
- Posts: 69
- Joined: Sat May 05, 2018 11:24 pm
- Model of CNC Machine: MillRight Mega V
- Location: Las Vegas, NV
Two Rail Sweep a tree
- Attachments
-
- Tree.pdf
- (2.87 MiB) Downloaded 112 times
- SteveNelson46
- Vectric Wizard
- Posts: 2282
- Joined: Wed Jan 04, 2012 2:43 pm
- Model of CNC Machine: Camaster Stinger 1
- Location: Tucson, Az.
Re: Two Rail Sweep a tree
Have you tried sculpting? Maybe adding a little base and draft. Then smoothing. The original pic is very low resolution so the finished quality will probably not be very good.
Steve
- highpockets
- Vectric Wizard
- Posts: 3667
- Joined: Tue Jan 06, 2015 4:04 pm
- Model of CNC Machine: PDJ Pilot Pro