Wahoo board
- vfauto
- Vectric Craftsman
- Posts: 196
- Joined: Sun Nov 08, 2009 3:43 pm
- Model of CNC Machine: Legacy Artsian 72"
- Location: West Springfield Ma.
- Contact:
Wahoo board
Wondering if any one has a Aspire file for a wahoo board they are willing to share?
Thank You
Frank
Frank
-
- Vectric Wizard
- Posts: 1479
- Joined: Sun Nov 28, 2010 5:10 pm
- Model of CNC Machine: Home built designs - 3'x4' and 5'x12'
- Location: Eastern NC, USA
Re: Wahoo board
A Google search for "Wahoo Board CAD files" found lots of links to info, photos, and files to make these boards.
CarveOne
CarveOne
CarveOne
http://www.carveonecncwoodcraft.com
http://www.carveonecncwoodcraft.com
-
- Vectric Craftsman
- Posts: 103
- Joined: Sun Feb 05, 2012 4:40 am
- Model of CNC Machine: Home built wooden machine - Mach3/Aspire
- Location: Fort Wayne, Indiana
Re: Wahoo board
Some people also call this an Aggravation board game....yes there are many examples on the internet with pics....This is an easy task to design with Vectric software as a 2D project using only vectors, no 3D required.
-
- Posts: 49
- Joined: Sat Feb 02, 2013 4:45 pm
- Model of CNC Machine: Legacy Arty 58
- Location: Fridley, MN
Re: Wahoo board
Here is a file I downloaded from the Shark CNC web site. I did not create it and don't remember who I should give credit too. But I assume since he/she shared it there I am OK sharing it here.
I made one for a good neighbor who loves the game. It goes under a lot of different names this file was called fastrack. It is not created for marbles as a lot of them are but I suspect
you can modify it easily. I did by using 3/16" holes for golf tees.
Enjoy. And again thanks to the unknown individual who shared it on the Shark web pages.
I am sharing it as a .crv file so the folk with VCarve and VCarve Pro can use it.
George
I made one for a good neighbor who loves the game. It goes under a lot of different names this file was called fastrack. It is not created for marbles as a lot of them are but I suspect
you can modify it easily. I did by using 3/16" holes for golf tees.
Enjoy. And again thanks to the unknown individual who shared it on the Shark web pages.
I am sharing it as a .crv file so the folk with VCarve and VCarve Pro can use it.
George
- Attachments
-
- Fastrack Board.crv
- (455 KiB) Downloaded 431 times
George
Fridley, MN
Legacy Arty, Aspire, CCAM
Fridley, MN
Legacy Arty, Aspire, CCAM